Georgia Firearm Forums - Georgia Packing banner
1 - 20 of 24 Posts

·
Registered
Joined
·
8,809 Posts
Discussion Starter · #1 ·
For my AR build, I'm going to put everything in this thread for now. I can start by listing what I ordered.

My cost stands at $756.64 for:

--Stripped Lower from Anvil Arms
--Transfer Fee/Shipping
--LPK/Upper (A2 Buttstock, C.A.R. HG, 16" Chrome-lined HBAR Barrel, GG&G M.A.D. rear sight)
-- 2 magazines with anti-tilt followers
--Tools (Pein hammer, small punch, needle nose pliers)

The lower is scheduled for delivery to my FFL tomorrow (Monday) and the upper/LPK should be here by the end of the week. I'll be detailing the build with pictures. I plan on doing the build this weekend.
 

·
Token Liberal Hippie
Joined
·
13,680 Posts
It amazes me that I can get every single other part of a gun shipped to me at home, but that little piece of plastic has to go through a dealer.

:roll:
 

·
Registered
Joined
·
1,521 Posts
To be correct, Forged Alluminum Alloy. That is the little part that has the serial number on it. All the rest are just parts and not regulated by the ATF.

Chris
 

·
Registered
Joined
·
4,864 Posts
Having seen some of these I can tell you one thing.
They will get jammed on whatever aperture you are using if you do not clean it almost any time they get dirty.

I've seen them freeze due to both saltwater and sand. and it's a pain to get free again.
 

·
Registered
Joined
·
5,798 Posts
cdtracing said:
ptsmith24 said:
ARMS sight is backordered. It is being substituted with the GG&G M.A.D. REAR SIGHT
This is same sight that is on my wifes 9mm carbine. It works great and co-witnesses perfectly with an Aim Point.

Chris

I'd have held out for the ARMS 40.
 

·
Atlanta Overwatch
Joined
·
13,951 Posts
If the Holidays roll around and I'm asking my wife for AR parts, it's all ya'lls fault!!! All this talk of AR's on the site recently is giving me the itch to build one. I think I need a second one. I'm thinking 9mm for cheap plinking.


Speaking of cheap plinking. Has anyone hear tried one of the .22 conversion kits for a .223 AR? I think Ceiner makes them. You use their .22 mag and bolt group in your .223 upper.
 
1 - 20 of 24 Posts
Top